Table of Contents
Advertisement
• RF (radio frequency) communication may come and go occasionally. This can be normal
in some environments (e.g. moister climates).
• If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be
patient – these stations can reconnect on, after many hours out.
• RF (radio frequency) communication is not always 100% on. Certain temporary
conditions can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
• If the sensor loses connection to the station for any reason, the station will show dashes
after 30 minutes.
• The station will search for 5 minutes every hour to reconnect with sensor.
• Be sure you have good batteries. Manually search for your sensor by holding the SENSOR
button for three seconds.
Try this:
• Bring your sensor within 10 feet of your station and make sure it is connected to the
station.
• After 15 minutes move the sensor into the next room with a wall between the sensor and
the station for 1 hour.
• If there is no loss of signal in that hour, move the sensor just outside.
• Continue moving the sensor back to its original location.
• If you lose connection, look for sources of
WHY AM I GOING THROUGH BATTERIES QUICKLY?
• Test a new set of
batteries.
• When the batteries fail, please note the date and voltage again. This is helpful in
determining the problem.
• Check for leaking batteries, which may damage the sensor.
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
• On your sensor, open the battery cover and press the F/C button. This will change the
temperature display on the sensor only.
• On your station enter the
display on the station.
• Check for debris or ice preventing cups from moving.
• Check mounting location. Look for obstructions that prevent the wind from reaching the
sensor.
• In most cases, the wind sensor needs to be 4-6ft above the highest point on the roof to
clear nearby obstructions and read accurately.
batteries.
Write down the date of installation and the voltage of the
program menu
WHY ARE MY WIND CUPS NOT SPINNING?
interference.
to select Fahrenheit or Celsius temperature
16 |
P a g e
Advertisement
Table of Contents
