Table of Contents
Advertisement
In the rare event you need to replace your sensor, you will first need to delete the old sensor
ID from your station.
1. Remove batteries from your old sensor.
2. Press and release the SENSOR button to view your sensor ID number.
3. While viewing your sensor ID, press the MINUS button for 5 seconds to delete your old
sensor ID. Dashes will show the ID number.
4. Your station will automatically begin searching for the new sensor.
5. Install batteries in your new sensor and allow up to three minutes for your new sensor
readings and ID to appear on your station.
FACTORY RESET: HOW DO I FACTORY RESET MY STATION?
• A factory reset will delete all sensor ID numbers and if connected, remove all Wi-Fi
connections.
• This is a great way to return your station to "out of the box" condition.
• This is more effective than removing all power for clearing out the station.
• All history records will be removed, so write down anything you want to keep.
To factory reset your station:
1. Hold the ALERTS and LIGHT buttons together for 5 seconds.
2. When your station resets it will look for all sensors. Allow at least ten minutes to reacquire
the sensors.
Note: if operating connected, you will need to reconnect to Wi-Fi from the app. Click
for details.
DASHES TEMP/HUMIDITY: WHY DOES MY THERMO-HYGRO SENSOR SHOW
Dashes indicate the connection is lost between your station and the outdoor sensor.
• My first thought is always to check that my
now is not, low batteries are the most common connection problem.
• Next, check your
previously at the same location, this is likely not the issue. However sometimes there is
new growth on trees or bushes that causes another barrier. Radio Frequency (RF) signal
does not travel well through foliage due to the moisture content.
• Occasionally adding a new wireless electronic device to the home will cross the signal
path for the sensor. If this occurs try moving your station a few feet or turning the
station 90 degrees for a better angle to receive the sensor signal.
HOW DO I DELETE SENSOR ID NUMBERS?
DASHES ON THE STATION?
distance, resistance and
batteries
are good. If it has been working and
interference. If everything was working
here
14 |
P a g e
Advertisement
Table of Contents
