Unloading - Hitachi ZAXIS 30U-5N Operator's Manual

Unloading

d
WARNING:
 Always turn the auto-idle switch (2) OFF when
loading or unloading the machine. In the auto-idle
mode, speed may automatically increase.
 The engine speed changes at the muffler filter
regeneration. Set the muffler filter manual
regeneration switch to the inhibition position.
 Always select the slow speed mode (1) with the travel
mode switch.
 Never steer while driving up or down a ramp as it is
extremely dangerous and may cause the machine to
turnover. NEVER attempt to change directions whilst
positioned on the ramp. If repositioning is necessary,
first move back to the ground or flatbed, modify
traveling direction, and begin to drive again.
 The top end of the ramp where it meets the flatbed is
a sudden bump. Take care when traveling over it as
the balance may be lost.
IMPORTANT: Make sure that the angle of the boom and
the arm is kept between 90 to 110 ° when unloading
the unit.
Damage to the unit is possible if the arm is kept in a
suspended state during unloading.
1. Travel extremely slowly with the bucket on the ground
and the angle of the arm and the boom kept at between
90 to 110 ° when moving from the edge of the truck onto
the ramp.
IMPORTANT: When driving the machine over the ramp,
do not allow the machine to hit the ground too hard
with the arm. Possible damage to the hydraulic
cylinders may result.
2. The bucket must be on the ground before the machine
begins to tip forward.
3. As the machine moves forward, raise the boom and
extend the arm until the machine is completely off the
ramp.
TRANSPORTING
6-6
1
2
3
MADH-01-009
MADB-06-004
MADB-06-005