Equipment Of Opg; Restriction Of Attachment Installation; Provide Signals For Jobs Involving Multiple Machines; Confirm Direction Of Machine To Be Driven - Hitachi ZAXIS 30U-5N Operator's Manual

Equipment of OPG

 In case the machine is operated in areas where the
possibility of falling stones or debris exists, equip genuine
Hitachi OPG guard. Contact your nearest Hitachi dealer for
installation method of the OPG guard. Depending on the
specifications applied to your machine, modification of the
machine to meet ROPS standards will be possible.
 To maintain unimpaired operator protection and
manufacture's protective structure.
 Damaged ROPS, OPG guard must be replaced, not
repaired or revised.
 Any alternation to the ROPS or OPG guard must be
approved by the manufacturer.
ROPS : Roll Over Protective Structure
OPG : Operator Protective Guard

Restriction of Attachment Installation

 Do not install an attachment which exceeds specified
weight for the machine structure.
Provide Signals for Jobs Involving Multiple
Machines
 In case more than one machine is operated in the same
job site, accidental collision between machines may cause
serious injury or death.
 For jobs involving multiple machines, provide signals
commonly known by all personnel involved. Also, appoint
a signal person to coordinate the job site. Make sure that all
personnel obey the signal person's directions.

Confirm Direction of Machine to be Driven

 Incorrect travel pedal/lever operation may result in serious
injury or death.
 Before driving the machine, confirm the position of the
undercarriage in relation to the operator's position.
 If the travel motors are located towards the front of the
cab, the machine will move in the reverse direction when
travel pedals/levers are operated.
SAFETY
S-11
SA-490
SA-481
SA-1294