Usb Type-C Board; Removing The Usb Type-C Board - Alienware P51E Service Manual

Steps
1. Connect the audio board to the system-board assembly.
2. Align the screw holes on the audio board with the screw holes on the system-board assembly.
3. Replace the two screws (M2x3) that secure the audio board to the system-board assembly.
4. Turn the system-board assembly over.
Next steps
1. Follow the procedure from step 6 to step 25 in
2. Install the rear-I/O cover.
3. Install the top heat-sink.
4. Install the small fan.
5. Install the wireless card.
6. Install the M.2 2230 solid-state drive
7. Install the M.2 2280 solid-state drive
8. Install the memory module.
9. Install the base cover.
10. Follow the procedure in

USB Type-C board

Removing the USB Type-C board

Prerequisites
1. Follow the procedure in
2. Remove the battery.
3. Remove the base cover.
About this task
The following image(s) indicate the location of the USB Type-C board and provides a visual representation of the removal procedure.
68
Installing the system
in slot three and four.
or M.2 2230 solid-state drive
After working inside your
Before working inside your
board.
in slot one and two, whichever applicable.
computer.
computer.