Usb/Sd; Connecting A Usb Device; Inserting The Sd - Kenwood DNR1008RVS Instruction Manual

USB/SD

Connecting a USB device

1
Connect the USB device with the USB
cable. (P.99)
2
Press the [ ][HOME] button.
3
Touch [
].
4
Touch [USB]. (P.14)
Ñ
Disconnect the USB device
1
Press the [[ ][HOME] button.
2
Touch a source other than [USB].
3
Detach the USB device.
Ñ
Usable USB device
You can use a mass-storage-class USB device
with this unit.
The word "USB device" appearing in this manual
indicates a flash memory device.
● About the file system
The file system should be the one of the
following.
• FAT16 • FAT32
NOTE
• Install the USB device in the place where it will
not affect safe driving.
• You cannot connect a USB device via a USB hub
and Multi Card Reader.
• Take backups of the audio files used with this
unit. The files can be erased depending on the
operating conditions of the USB device.
We shall have no compensation for any damage
arising from any erased data.
• exFAT • NTFS

Inserting the SD

1
Tilt the panel toward you manually.
2
Insert the SD card into the slot until it
clicks.
3
Close the panel.
4
Press the [[ ][HOME] button.
5
Touch [
].
6
Touch [SD]. (P.14)
Ñ
Remove the SD card
1
Press the [[ ][HOME] button.
2
Touch a source other than [SD].
3
Tilt the panel toward you manually.
4
Push the SD card until it clicks and then
remove your finger from the card. The
card pops up so that you can pull it out
with your fingers.
5
Close the panel.
Ñ
Usable SD card
The unit is capable of playback of SD/SDHC/
SDXC memory cards complying with the SD,
SDHC or SDXC standard. A special adapter is
required to use a miniSD card, miniSDHC card,
microSD card, microSDHC, or microSDXC card.
The MultiMedia Card (MMC) cannot be used.
USB/SD
29
English