Speaker / X'over Setup - Kenwood DNR1008RVS Instruction Manual

NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the smartphone/cell-phone of Bluetooth HF/
Audio
– Beep for User Interface Setup
• While talking on the paired phone or using the
voice recognition function, the speaker system
cannot be switched.
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched to the 3-way
mode.

Speaker / X'over setup

1
Press the [ ][HOME] button.
2
Touch [ ].
3
Touch [Audio].
h Audio screen appears. h
4
Touch [Speaker / Xʼover].
5
Select a car type.
You can select the car type and speaker
network, etc.
When you select your car type, the Delay
Time Alignment is activated automatically
(for timing adjustment of sound output for
each channel) to have the highest surround
effects.
6
Touch the speaker (1) you wish to adjust
and set each parameter (2) as follows.
2
■ [Speaker]
You can select a speaker type and its size to
get the best sound effects.
When the speaker type and size are selected,
the speaker crossover network is set
automatically.
[Location] (Only for Front, Rear)
■
Select the speaker position you have
installed.
[Tweeter] (Only for Front)
■
You can set up the tweeter when you are
selecting front speakers.
None, Small, Medium, Large
[HPF FREQ] (Only for Front, Rear)
■
High Pass Filter adjustment.
[LPF FREQ] (Only for Subwoofer)
■
Low Pass Filter adjustment.
■ [Slope]
Set a crossover slope.
■ [Gain]
Adjust the gain of the front speaker, rear
speaker, or subwoofer.
[TW Gain] (Only for Front)
■
Adjust the tweeter level.
[Phase Inversion] (Only for Subwoofer)
■
Set the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees.
Controlling Audio
1
2
English
75