Configure Connect-Iws System; Required Materials; Table 21: Installation: Installer Supplied Materials; Figure 35: Configuration: Connect-Iws System Configuration Block Diagram - Redline Connect Series Installation Manuallines

CONNECT-OWS
4.4

Configure Connect-IWS System

All configuration is performed using the Connect-IWS web interface. Use the following
steps to configure the Connect-IWS serial ports and setup a link to the base station:
Connect an Ethernet cable from the test PC to Connect-IWS port ETH 1 or ETH 2.
1.
Power-on the Connect-IWS.
2.
Open a Web browser and login to the Connect-IWS management interface.
3.
Configure the network, serial ports and wireless settings.
4.

Figure 35: Configuration: Connect-IWS System Configuration Block Diagram

4.4.1

Required Materials

Configuration of the Connect system settings requires additional equipment and
materials supplied by the installer. The following list is a guideline only, and additional
materials may be required based on local conditions at each installation site.
# Item
1 Cabinet
2 Ethernet Cable
70-00200-03-00
Installation Guidelines

Table 21: Installation: Installer Supplied Materials

Description
Portable computer with Web browser.
crossover
A CAT-5e
Proprietary Redline Communications © 2014
cable terminated with RJ-45 at both ends.
Page 48 of 62 December 3, 2014