Printronix P5000 Series Setup Manual page 35

Cabinet Model
Host Interface
Connectors
I/O Cover
Cable-Routing
Notch (2)
1. Make sure the printer power switch is set to OFF (see Figure 21).
Connect the (customer-supplied) interface cable from the host computer
to the appropriate printer interface connector (see Figure 20). Refer to
Chapter 5, "Interfaces," for descriptions of the connectors and their pin
assignments.
a. Remove the cover from the interface connector you have selected.
b. Hold the interface cable below its connector, and gently attach the
2. Plug the power cord into the printer AC power connector, then into the AC
power outlet (see Figure 21).
OFF/ON
AC Power
Connector
AC Power Cable
pq$rv‚
Figure 21. Interface and Power Locations
cable connector to the printer interface connector.
Connect the Interface and Power Cables
Host Interface
Connectors
Pedestal Model
Power Switch
AC Power Connector
35