Overview - Omron V330-F Series Quick Start Manual

4. Overview

This document describes the procedures for connecting the OMRON code reader products
(V330-F/V430-F Series) to an NJ Series Machine Automation Controller (hereinafter referred
to as the controller) via Ethernet and for checking their connections.
You can establish an Ethernet communication connection by understanding the setting
procedures and key points of setup through the Ethernet communication settings in the
project file prepared in advance.
In this project file, the Ethernet connection is checked by sending a read trigger command to
the code reader and receiving the read data from it.
Obtain the latest version of the Sysmac Studio Project File from OMRON in advance.
Name
Sysmac Studio Compact
Project File (Extension: smc2)
The purpose of this document is to describe the wiring methods, communication
settings, and setting procedures required to establish a connection for
communications with applicable devices. In addition, the program used in this
document is designed to check that the connection has been correctly
performed (connection check). Since the program is not intended for permanent
use on-site, full consideration is not given to functionality and performance.
When configuring an actual system, please refer to the wiring methods,
communication settings, and setting procedures described in this document to
design and create a program that meets your purpose.
Filename
OMRON_V330_V430_NJ_ETN(TCP)_V100.
smc2
4. Overview
Version
Ver. 1.00
4