Omron V330-F Series Quick Start Manual page 17

6
When the WebLink startup
screen is displayed, go to step
8.
If you cannot access by
WebLink, go to step 7.
7
If the WebLink startup screen does not appear, it means that communications are not
established between the code reader and the PC. Please check the following.
• The code reader and the PC have a proper physical (cable) connection.
→ Refer to steps 1 and 2 for checking the connection.
• The IP Addresses of the PC and code reader are set correctly.
→ Refer to step 4 for setting the IP address of the PC.
For other measures that can be taken, please refer to When unable to access by WebLink in
Q&A in Appendices of the MicroHAWK V320-F/V330-F/V420-F/V430-F Series Barcode
Reader User Manual (Cat. No. Z432).
8
The WebLink screen appears.
9
Click on the Setup Tab and, in
Read Cycle Sequence, set
Cycle to Triggered.
10
Click on the gear icon on the
upper right of the screen and
select Advanced.
7. Connection Procedure
14