Removing inner rails from the rail assemblies
Table 9 Mounting kit parts (continued)
Component
Four Phillips pan-head 8-32 x 0.35 in
screws
1U bezel (application specific)
You need a # 2 Phillips-head screwdriver to complete the installation of the rails and
server.
Perform the procedure that follows on each rail assembly. Refer to
34 while performing the procedure.
Procedure
1. Slide the inner rail out from the slide rail as far as possible.
2. On the inner rail, slide the blue disconnect tab forward to release the inner rail
from the slide rail.
3. Slide the inner rail completely out of the slide rail.
Use
Stabilize the server and rail mounting
Covers front of server in cabinet
CL4887
Removing inner rails from the rail assemblies
Equipment Installation
Figure 10
on page
33