Installing And Removing Chassis Static Rail Modules; Figure 1-6. Installing The Versarails Mounting Rails - Dell PowerEdge 860 Hardware Installation Manual

Figure 1-6. Installing the VersaRails Mounting Rails

mounting-bracket flange
10-32 x 0.5-inch
flange-head Phillips
screws (4 per
mounting rail)
front of rack

Installing and Removing Chassis Static Rail Modules

NOTE:
modules from the chassis.
1 To install the rails, locate the J slots on both rails. Locate the two corresponding shoulder
screws that are on both sides of the chassis toward the front and midpoint (see Figure 1-7).
2 To attach the rails to the chassis, align the two J slots on the rail modules with the shoulder
screws. Position each rail directly below the two corresponding shoulder screws
(see Figure 1-7).
3 To seat the rails, pull up on the front latches attached to the front of each rail. Pull up
and back on each rail, snapping them into place on the chassis.
4 To remove the rails from the chassis, pull up on the front latches to release each rail.
5 Unseat the rails from the J slots and remove the rails from the chassis.
14
Rack Installation Guide
You do not need to remove the optional front bezel to install or remove the chassis static rail
rails modules (2)