3. Connect the camera cable, display cable, battery cable, speaker cable, clickpad flexible flat cable, USH daughter board
flexible flat cable (for models shipped with a USH daughter board), RTC cable, finger print reader power button cable,
Darwin cables, and P cable, on the system board.
4. Connect camera and display cables on the system board.
5. Replace the six screws (M2x3) securing the display, camera, and USB Type-C brackets.
Next steps
1. Install the heat-sink.
2. Install the
2-cell battery
3. Install the
M.2 2230 solid-state
4. Install the
base
cover.
5. Follow the procedure in
WLAN-antenna module
Removing the WLAN-antenna module
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
M.2
SSD.
4. Remove the
WWAN
card.
5. Remove the
2-cell battery
6. Remove the
heat
sink.
7. Remove the
system
board.
About this task
NOTE:
This procedure applies only to computers shipped with a WLAN-antenna module installed on the palm-rest and
keyboard assembly.
The following images indicate the location of the WLAN-antenna module and provide a visual representation of the removal
procedure.
or
the3-cell
battery, whichever is applicable.
drive.
After working inside your
Before working inside your
or
the3-cell
battery, whichever is applicable.
computer.
computer.
Removing and installing components
53