Steps
1. Route the antenna cables from the routing guide.
2. Using the alignment posts and rubber grommets, place the speakers into the slots on the palm-rest and keyboard assembly.
3. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly. Then secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
4. Connect the speaker cable to the connector on the I/O daughter-board.
Next steps
1. Install the
base
cover.
2. Install the
WWAN
card.
3. Follow the procedure in
Removing the speakers for mainstream
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
42
Removing and installing components
Before working inside your
Before working inside your
computer.
computer.