Display Assembly; Removing The Display Assembly - Dell Latitude 7340 Service Manual

Steps
1. Place the coin-cell battery into its slot on the system board.
2. Route the coin-cell battery cable back to the routing guides on the system board.
3. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in

Display assembly

Removing the display assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the WWAN card.
NOTE: This procedure applies only to computers shipped with a WWAN card installed.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
36 Removing and installing components
After working inside your
Before working inside your
computer.
computer.