NOTE:
If the rubber grommets are pushed out during speaker removal, make sure to reinsert them before reinstalling
the speakers.
3. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly. Then secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
4. Connect the speaker cable to the connector on the I/O daughterboard.
Next steps
1. Install the
base
cover.
2. Install the
WWAN
card.
3. Follow the procedure in
Removing the speakers for mainstream
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Figure 33. Removing the speakers for mainstream
Steps
1. Disconnect the speaker cable from the connector on the system board.
2. Peel the tape that secures the speaker cable to the palm-rest and keyboard assembly.
3. Note the speaker cable routing, and unroute the speaker cable from the routing guides on the palm-rest and keyboard
assembly.
4. Lift the speakers, along with the cable, off the palm-rest and keyboard assembly.
62
Removing and installing Customer Replaceable Units (CRUs)
Before working inside your
Before working inside your
computer.
computer.