Using The Remote Control; Setting Main Operating Mode - Bosch Climate Line 5000i Series Manual

Pos. Symbol Explanation
1 Operating function: indirect airflow is active
(Wind avoid me).
Infographic: self-cleaning is active (I clean).
Operating function: fresh air function is active
(Ionizer).
Operating function: sleep mode is active.
Operating function: follow me function is active
(Follow Me); temperature measurement at the
remote control.
Infographic: wireless control function.
Infographic: battery status
2 Operating mode: automatic mode
Operating mode: cooling mode
Operating mode: dehumidification mode
Operating mode: heating mode
Operating mode: fan mode
3 Value display: shows the set temperature, fan speed
or (when timer is activated) the timer setting as
standard.
Infographic: transmission indicator, lights up when
the remote control sends a signal to the indoor unit.
Infographic: energy saving function active.
Infographic: energy saving function active.
Infographic: ON/OFF timer active.
Infographic: noise reduction is active (Silent Mode).
Value display: shows the current fan speed. There are
several output stages (bars) and the AUTO setting for
automatic control.
4 Infographic: automatic vertical swing function is
active (up/down). Alternatively, display of the current
position of the horizontal louver.
Infographic: automatic horizontal swing function is
active (left/right).
Infographic: Turbo cool/Turbo heat is active.
Table 5 Symbols in the display
3.3

Using the remote control

The signal range is 8 m. If objects are in the way or certain fluorescent
lamps are used in the same room this can affect transmission of the
signal.
▶ Point the remote control towards the signal receiver window of the
unit and press the desired key.
The unit emits a beep when it receives a signal.
NOTICE
The remote control may be permanently prevented from working
correctly.
▶ Do not expose the remote control to direct sunlight.
▶ Do not leave the remote control near a heating appliance.
▶ Protect the remote control from moisture and impacts.
Climate Line 5000i – 6721831692 (2021/02)
3.4

Setting main operating mode

Turn unit on/off
▶ Press the K key to switch the device on or off:
The device starts in the set operating mode.
Settings can also be made when the device is switched off. The device
saves the settings, and also retains them in the event of a power failure.
Automatic mode
In automatic mode, the device automatically switches between heating
and cooling mode to maintain the desired temperature.
▶ Press the Mode key repeatedly until
▶ Select the required temperature with the . and / keys.
The fan speed cannot be adjusted in automatic mode.
Cooling mode
▶ Press the Mode key repeatedly until
▶ Press the key until the required air speed is reached.
▶ Select the required temperature with the . and / keys.
Fan (Only) Mode
▶ Press the Mode key repeatedly until
▶ Press the key until the required fan speed is reached. AUTO can
be selected to enable automatic control.
The temperature cannot be adjusted or displayed in Fan Mode.
Dehumidification mode
▶ Press the Mode key repeatedly until
▶ Set the required temperature with the . and / keys.
The fan speed cannot be adjusted in dehumidification mode.
Heat mode
▶ Press and hold the Mode key until
▶ Set the required temperature with the . and / keys.
▶ Press the key until the required air speed is reached.
If the outside temperature is very low, the heating capacity of the air
conditioning system may not be sufficient. We recommend connecting
additional heat sources.
Operation
appears on the display.
appears on the display.
appears on the display.
appears on the display.
appears on the display.
21