Product Information; Declaration Of Conformity; Specifications Of Remote Control; Operating Temperature Range - Bosch Climate 5000i M Operating Instructions For Users

Product Information

2 Product Information
2.1

Declaration of conformity

The design and operating characteristics of this product comply with the
European and national requirements.
The CE marking declares that the product complies with all the
applicable EU legislation, which is stipulated by attaching this
marking.
The complete text of the Declaration of Conformity is available on the
Internet: www.bosch-industrial.com.
2.2

Specifications of remote control

Power infeed 2 AAA batteries
Signal range 8 m
Permissible ambient 16... 30 °C
temperature
Table 42 Specifications of remote control
2.3

Operating temperature range

Room temperature
Cooling 16 ... 32 °C
Heating 0 ... 30 °C
Dehumidifying 10... 32 °C
Table 43
The built-in protection device may prevent the appliance from operating
at temperatures outside the above range.
If the humidity is more than 80 %, condensation may form at the air
outlet. To prevent this, open the vertical ventilation flaps as wide as
possible (vertical relative to the ground) and set a high fan output.
44
Outside temperature
−15... 50 °C
−15... 24 °C
3

Operation

3.1

Unit overview

Indoor unit overview
Key to Fig. 2:
[1] Condensate pump (for draining condensate from the indoor unit)
[2] Condensate hose
[3] Display
[4] Return air inlet
[5] Air inlet
[6] Air Outlet
3.2

Indoor unit display

Key to figure 3:
[1] LED display
[2] Infrared signal receiver
[3] Status indicator
[4] Timer indicator
[5] Manual operation
[6] Pre-heating and defrosting indicator
[7] Alarm indicator
The operating modes can be selected in the sequence automatic mode,
cooling mode and shutdown via the Manual operation key.
Manual button
Operating Display
mode
Automatic Operation
mode indicator on
Manual cooling Status
mode indicator
flashes
Shutting-down All indicators
off
Table 44 Indications on the display unit
3.3

Remote control overview

Keys on remote control
 Fig. 3
Pos. Key Function
K
1 Switch on/off.
Mode Set operating mode.
2 SET Select advanced operating functions.
OK Confirm choice.
Set timer.
.
Increase temperature.
/
Reduce temperature.
3 Fan step
Swing Set swing function.
Indirect airflow is active (Wind avoid me).
Turbo Turbo cool/Turbo heat
LED Switch display of indoor unit and alarm buzzer on and
off (Mute Mode).
Table 45 Keys on remote control
Climate 5000i M – 6721849824 (2022/11)
Display output
Cooling and heating modes:
Set temperature
Fan only mode:
Indoor ambient temperature
The system automatically switches to
automatic mode after 30 minutes of
forced cooling. The remote control is
deactivated during forced cooling.
If the display is switched off, the indoor
unit switches off and the remote
control is reactivated.