Table of Contents
Advertisement
a)
Loosen the bolts and dismount part 20 (see pic.24).
b)
Loosen the bolts and dismount part 19 (see pic.25).
c)
Using the special tools 29 and 30, loosen the bolt fixing the circular saw blade (see pic. 26).
d)
Reversed order assembly.
4. POWER SUPPLY
ATTENTION! When working with non-grounded machines:
Severe injury or even death may arise though electrocution!
Therefore: The machine must be operated at a grounded power socket.
The electrical connection of the machine must be carried out by a qualified electrician only. In addition, the qualified
electrician must check the following points:
The electronic connection of the machine is designated for operation with a grounded power socket!
The mains supply must be secured with a 16A current.
If the connector plug doesn't fit or if it is defect; in case of malfunction only qualified electricians may modify or re-new
it.
The grounding wire should be held in green-yellow.
Check, whether the feeding voltage and the frequency comply with the required values of the machine. A deviation of
feeding voltage of ±5% is allowed (e.g.: a machine with working voltage of 380V can work within a voltage bandwidth of
370 till 400V).
After connecting, check the right running direction.
Make sure that a possible extension cord is in good condition and suitable for the transmission of power. An
undersized cord reduces the transmission of power and heats up.
If the cable is damaged. If cable is damaged or doesn't work correctly, it must be immediately replaced.
NOTICE! Operation is only allowed with safety switch against stray current (RCD max. stray current of
30mA)
NOTICE! Use only permitted extension cable with cross-section the one in the following table declared.
PIC.26
13
Advertisement
Table of Contents
