Table of Contents
Advertisement
GENERAL
Programming Items Factory set Default Programming Range (display)
Ready Temp
Brew at Temp.
Units of Meas.
<Toggle Temp-Vol.>
<Toggle Temp-Vol.>
Logo Timeout
BREW AT TEMP: AUTO
(DEFAULT: FACTORY PROGRAMMED INTO BREWER)
This allows the "BREW START" to active.
If the hot water tank is at the selected temperature—the brew will start.
If the temperature is too low—not at the selected temperature, the brewer will wait until the
proper temperature is reached and then will automatically begin brewing.
A thermometer icon screen will display showing the tank temperature. (example: right)
ALWAYS have dispenser(s) under the brew baskets when in the BREW AT TEMP mode.
BREW AT TEMP: OFF
Allows brewing at any temperature. (Not recommended-it is possible to start brew with brew water at incorrect temperature.)
INPUTS
Programming Items Factory set Default
Display Inputs
• Input Summary
Cal. Touch Scr
Go to fetco.com for the latest versions of all information
"OFF" allows brewing
AUTO
at any temperature.
• Temperature
°C
Liters
• Volume
1:00 mm:ss
NOTE: FOR BREW AT TEMPERATURE DEFINITIONS
IMPORTANT:
USER SELECTABLE
Calibrate
+ / - 2°C
Programming Range (display)
Brew Basket Sensor
Liquid Level Sensor
Temperature Probe
SD Card
________________[]____
Page 8
User Guide & Operator instructions
+ / - 2°C
|______[]__________|
1
5
AUTO
|____________[]___|
OFF
AUTO
°C
|____________[]___|
°F
°C
Liters
|_____________[]__|
Gallons
Liters
1:00 mm:ss
|_[]_______________|
0:00
5:00
1
6.00L
10:36
°C
90.0
Calibrate
YES
NO
P152 rev.003 August 2021
Notes
Range when
"READY" icon
will show
SEE NOTE!
(Below)
87°
(<set point)
STOP
Notes
If Yes:
Follow directions
on the touch
screen
Advertisement
Table of Contents
