Fetco TBS-2111 User’s Manual & Operator Instructions page 7

.PROGRAMMING MENU-Continued
PROGRAM Programming
Continued Items
(See Batch 2)
Batch 3
(See Batch 2)
Batch 4
(See Batch 1)
Batch 5
(See Batch 2)
Batch 6
(See Batch 2)
Batch 7
(See Batch 2)
Batch 8
Batch Copy
Copy From Batch
Copy To Batch
Copy?
*
Batch 1& 5 are mandatory and cannot be disabled. Other batches can be disabled ["hidden"], and removed from display
Programming Batch Temperature
Individual temperature settings can be programmed for all eight recipes. This accommodates many different brew
temperature requirements of the tea product used. The hot water tank temperature automatically sets to the lowest
programmed recipe setting. If a brew is started for a higher temperature setting, the brewer will pause and quickly heat
the hot water tank to the temperature setting of the recipe before starting the brew. This is rapid: taking only minutes.
Tank temperature is too low for brew setup
1) If the tank temperature is LOWER than the temperature setting—the brewer will display the "Not Ready" icon:
The hot water tank will quickly reheat and the "Ready" icon will display when heated to the set temperature:
Tank temperature is too high for brew setup
2) If the tank temperature is HIGHER than the temperature setting—the brewer will flash the "PURGE" icon:
"PURGE" to cool feature
Purge is drawing a small amount of hot water from the hot water tank—the temperature of the tank is automatically
reduced by cool, fresh refill water from the mains. When the "PURGE" icon is activated for 5 seconds approximately
≈150ml/4 fl.oz hot water is released as bypass water and the tank temperature is reduced.
a) The hot water tank temperature can be quickly lowered by touching the "PURGE" icon for five seconds.
The single purge is adequate for most adjustments.
Note: the purged water increases the contents of the dispenser. The 150ml released is a negligible addition for most
brews—but should be noted for dispensers without headspace or for multiple purges
b) Water may be drawn from the hot water service faucet to lower hot water tank temperature.
The "PURGE" function is preferred as it offers better control.
c) Tank temperature override
The brew can be started at the high temperature by touching and holding the "START" icon to override the icon.
The brew may be exposed to some brewing water that is higher than temperature setpoint.
Recipe temperature setting table
GENERAL
Factory Set
Temperature Summary
1 90°C 5 90°C
2 90°C 6 90°C
3 90°C 7 90°C
4 90°C 8 90°C
.
Go to fetco.com for the latest versions of all information
Factory set Default
COPY from B.(1-8)?
COPY to B.(1-8)?
B1B2?
(example)
SETTINGS BY USER
Temperature Summary as Set By
User
Fill this in and save for future
reference
1
2
3
4
Page 7
Programming Range
NO
|_______________
YES
Purge to lower brew water temperature
Recipes show the
temperature setting. These
can be set by user from 80-
Touch the purge icon for 5
5
sec. This will lower hot water
tank temperature 3-4
6
degrees
7
8
User Guide & Operator instructions
__|
[]
NO
97°.
PURGE Icon
P152 rev.003 August 2021
Notes