Overheating Protection - BRAYER BR4208 Instruction Manual

10 EN
Cleaning the cyclonic filter (24) and the filters (25, 26)
installed in the dust bin (11)
• Preliminarily remove dust and garbage from the dust
bin (11) as described above.
• Turn the lid (23) counterclockwise and remove it.
• Remove the foam filter (26), remove the inlet filter (25)
and the cyclonic filter (24).
• Clean the cyclonic filter (24) from dust and garbage.
• Wash the cyclonic filter (24) under warm water jet and
dry it.
• Wash the inlet filter (25) and the foam filter (26) under
warm water jet and dry it.
• Do not wash the parts in a dishwashing machine.
• Dry the filter (25, 26) thoroughly.
• Do not dry the filter (25, 26) with a hairdryer or similar
appliances.
• Wash the dust bin flask (22), wipe it and dry.
• Insert the cyclonic filter (24) in the flask (22).
• Insert the inlet filter (25) and the foam filter (26) into the
cyclonic filter (24).
• Install the lid (23) and turn it clockwise as far as it will
go.
• Install the assembled dust bin (11) back to its place,
make sure that the dust bin (11) is fixed properly.
Attention! Before assembling and installing the dust bin
(11) back to its place make sure that the cyclonic filter
(24), the filters (25, 26) and the flask (22) are dry.
Cleaning the outlet HEPA filter (19)
• Switch the vacuum cleaner off and unplug the power cord
plug from the mains socket.
• Remove the outlet filter grid (18) turning it clockwise and
remove the outlet HEPA filter (19) (pic. 3).
• Wash the outlet HEPA filter (19) and the grid (18) under
lukewarm water jet. Do not wash the outlet HEPA filter
(19) and the grid (18) in a dishwashing machine.
• Dry the outlet HEPA filter (19) and the grid (18). Do
not dry the HEPA filter (19) with a hairdryer or similar
appliances.
• Install the outlet HEPA filter (19) back to its place.
• Install the grid (18) back to its place, turn the grid (18)
counterclockwise as far as it will go.
Vacuum cleaner body
• Clean the vacuum cleaner body with a soft, slightly damp
cloth, and then wipe it dry. Provide that no liquid gets
inside the vacuum cleaner body.
• Do not use solvents or abrasives for cleaning the vacuum
cleaner body and the attachments.
• Do not immerse the vacuum cleaner body, the power cord
and the power plug into water or any other liquids.

OVERHEATING PROTECTION

• If the electric motor gets too hot during the operation, the
overheating protection system will be set off.
• If during cleaning the vacuum cleaner has switched off,
press the on/off button (16) and unplug the unit.