Table of Contents
Advertisement
• To protect the power supply of the machine against current leakages, install a high-
sensitivity manual reset RCD (Residual Current Device), suitable for overvoltage
category III.
• For protection against indirect contacts (depending on the type of supply provided for
and connection of earths to the equipotential protection circuit
EN 60204-1 (IEC 60204-1) with the use of protection devices that ensure automatic cut-
off of the supply in case of isolation fault in the TN or TT systems or, for IT systems, the
use of isolation controllers or differential current protection devices to activate automatic
power disconnection (an isolation controller must be provided for indicating a possible
first earth fault of a live part, unless a protection device is supplied for switching off the
power in case of a such a fault. This device must activate an acoustic and/or visual
signal which must continue for the entire duration of the fault). For example: in a TT
system, a residual current device with cut-in current (e.g. 30 mA) coordinated with the
earthing system of the building where the machine is located must be installed ahead of
the supply.
• Make sure to install an emergency switch at the infeed and outfeed of the rack-type
dishwasher. For all additional modules installed later, move the emergency switch at the
ends of the equipment.
• For all the additional modules installed later, make sure that the power cable supply is
properly sized.
A.8
Service
• Only original spare parts can ensure the safety standards of the appliance.
A.9
Disposal of packing
• Dispose of each packaging items respecting the current regulation in the country of
installation.
A.10
Machine disposal
• Work on the electrical equipment must only be carried out by a specialised personnel,
with the power supply disconnected.
• Dismantling operations must be carried out by specialised personnel.
• Make the appliance unusable by removing the power cable and any compartment
closing devices, to prevent the possibility of someone becoming trapped inside.
• Refer to "A.3 Personal protection equipment" for suitable personal protection equipment.
• When scrapping the machine, the "CE" marking, this manual and other documents
concerning the appliance must be destroyed.
IMPORTANT
Save these instructions carefully for further consultation by the various
operators.
B
WARRANTY
B.1
Warranty terms and exclusions
If the purchase of this product includes warranty coverage,
warranty is provided in line with local regulations and subject to
the product being installed and used for the purposes as
designed, and as described within the appropriate equipment
documentation.
Warranty will be applicable where the customer has used only
genuine spare parts and has performed maintenance in
accordance with Electrolux Professional user and mainte-
nance documentation made available in paper or electronic
format.
24
Electrolux Professional strongly recommends using Electrolux
Professional approved cleaning, rinse and descaling agents to
obtain optimal results and maintain product efficiency over
time.
The Electrolux Professional warranty does not cover:
• service trips cost to deliver and pick up the product;
• installation;
• training on how to use/operate;
) refer to point 6.3.3 of
Advertisement
Table of Contents
