Step 6-Connect The Terminal Equipment - GE MDS entraNET Series Startup Manual

PC Running Terminal Session
(19,200 bps, 8N1)
Figure 5. Remote Configuration Setup
b. Login to the remote radio:
ENTER
• Press
(The
COM1
• At the
entranet>
• At the next prompt, enter the username (the default username is
). Press
admin
• At next prompt, enter the password (the default password is
). Press
admin
mands.
c. Set or Verify Network Address:
• Type
RADIO NETADDR=
network address.
• If changes are required, type
where
<netaddr>
address of the Remote radio must match that of the AP.)
7. Verify that the
with the AP. (It may take several seconds for the LED to light.)
Step 6—Connect the Terminal Equipment
Be sure not to overload the radio network with high-bandwidth LAN
traffic during this test. Refer to the
for more information.
(05-4055A01)
05-4565A01, Rev. A
several times to receive the
/ LED blinks to indicate data communication.)
ETH
prompt, enter
ENTER .
ENTER
. The radio is now ready to accept com-
to display the currently programmed
is 1-15 alphanumeric characters. (The network
LED lights to indicate successful connection
LINK
MDS entraNET Start-Up Guide
Invisible place holder
Invisible place holder
Invisible place holder
Invisible place holder
Invisible place holder
entranet>
ENTER
. Press
login
RADIO NETADDR=<netaddr>
MDS entraNET System Guide
Remote
COM1 Port
prompt.
.
,
11