Step 5-Connect Lan Or Serial Data Equipment - GE MDS Mercury Series Reference Manual

Item
Network Name
IP Address
RF Output
Power
Unit Password
26
Table 2-1. Basic Configuration Defaults
Menu Location
Main Menu>>
Radio Configuration>>
Network Name
Main Menu>>
Network Configuration>>
IP Address
Main Menu>>
Radio Configuration>>
Transmit Power
Main Menu>>
Device Information>>
User Password
For benchtop evaluation, configure:
• Frequency Mode = Single Channel
•
Single Frequency Channel
• = 1.75
RF Bandwidth
• TDD Sync = Free Run
For more information on configuring these parameters,
Control Menu" on Page
A unique IP address and subnet are required to access all IP-based man-
agement interfaces (telnet, SSH, SNMP, and Web), either through the
LAN
port or remotely over-the-air.
2.6 STEP 5—CONNECT LAN OR
SERIAL DATA EQUIPMENT
Connect a local area network to the
COM1
(DCE) port. The
equipment. This includes devices that use Internet Protocol (IP).
Figure 2-3 on Page 27
of the standard transceiver (Remote). The Option 1 Set Remote connec-
tors are shown in Figure 2-4 on Page
NOTE: The use of shielded Ethernet cable is recommended for
connection to the radio's
emission standards without shielded cable, but shielding
reduces the possibility of interference in sensitive environ-
ments, and is in keeping with good engineering practice.
Mercury Reference Manual
Default
MDS-Mercury
192.168.1.1
+29 dBm (900 model)
+23 dBm (3650 model)
admin
(lower case)
= 0
65.
LAN
port or a serial device to the
LAN
port supports any Ethernet-compatible
shows the interface connectors on the front panel
28.
ETH
port. The radio meets regulatory
Values/Range
• 1–15 alphanumeric
characters
• Case-sensitive;
can be mixed case
Contact your network
administrator
AP: -30 to +29 dBm
RM: 0 to +29 dBm
• 1–13 alphanumeric
characters
• Case-sensitive;
can be mixed case
see "Frequency
05-4446A01, Rev. D