Fast Track Installation Guide
Four anti-slide bumpers for desktop installation.
•
This Fast Track Installation Guide.
2.3
Mounting the MG 3200
The MG 3200 can be mounted on a desktop, or installed in a standard 19-inch rack. Refer to
Section
2.4
on page
2.3.1
Mounting the MG 3200 on a Desktop
No brackets are required. Optionally, attach the four (supplied) anti-slide bumpers to the base of
the MG 3200 and place it on the desktop in the position you require.
2.3.2
Installing the MG 3200 in a 19-inch Rack
Users can install the device in a standard 19-inch rack either by placing the device on a shelf
preinstalled in the rack (preferred method), or by attaching the device directly to the rack's frame
via integral brackets.
Before rack mounting the chassis, attach the two (supplied) brackets to the front sides of the
device (refer to
To attach the two front side brackets, take these 3 steps:
1.
Remove the 2 screws nearest the front panel on either side of the device.
2.
Align a bracket over 2 holes on one side (so that the bracket's larger holes face front) and
with the 2 supplied replacement screws, screw in the bracket.
3.
Perform the same procedure on the other side.
Version SN09
Figure 2-2: 19-inch Rack & Desktop Accessories
15
for cabling the MG 3200.
Figure
2-3).
13
2. Installing the MG 3200
August 2005