Section Ii-Nightlight; Nightlight Function - Oregon Scientific RMR966PA Instruction Manual

Radio-controlled projection clock with nightlight & indoor/ remote thermometer

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

During the pre-alarm operating period, if the temperature recorded

by the remote sensor falls to or below 2ºC, the pre-alarm feature

will be triggered. For example, if the alarm time is set to go off at

7:00a.m. and the pre-alarm operating time-interval is set to

45 minutes, the pre-alarm will start to operate at 6:15a.m.

(i.e., 45 minutes before the preset 7:00a.m.). The pre-alarm icon

will flash and the backlight and projection will be turned on for

5 seconds. An alarm sound will also go off for 2 minutes as that of

the daily alarm.

The snooze function will be activated if the [SNOOZE/LIGHT]

button is pressed.

Note:The daily alarm will NOT function until the next day if

the pre-alarm has been triggered beforehand. Deactivation

of the alarm function will disable the pre-alarm feature

automatically.

HOURLY CHIME FUNCTION

When the hourly chime function is on, the indication "

displayed and a beep sound will be given out at the beginning of

each hour. You can activate or deactivate this function by setting

this in the clock and calendar setting mode (please refer to Section

"SETTING THE CLOCK AND CALENDAR MANUALLY").

NIGHTLIGHT FUNCTION

This unit is attached with a LED-Nightlight at the side which acts

as a good bed-side feature. It can only be operated when AC power

is connected to the unit.

To turn on the nightlight, connect the unit to the AC power. Slide

the [LIGHT AUTO-ON-OFF] to the "ON" mode. To turn it off,

slide the [LIGHT AUTO-ON-OFF] to the "OFF" mode.

You can also set the Nightlight to turn on or off automatically.

To activate this auto function:

Slide the [LIGHT AUTO-ON-OFF] to the "AUTO" mode.

Adjust the sensitivity of the Light sensor by rotating the

[LIGHT SENSOR] knob inside the battery compartment so

that it can light up in the desired light intensity.

For example, if you want the Nightlight to be turned on

automatically in a darker environment, reduce the sensitivity

by rotating the [LIGHT SENSOR] knob towards the "-" side.

Conversely, if you want the Nightlight to be turned on

" will be

automatically in a brighter environment, increase the sensitivity

sensitivity by rotating the [LIGHT SENSOR] knob towards

the "+" side.

To change the direction of the Nightlight orientation, you can rotate

the Nightlight according to the arrow indication.