Getting Started; Batteries; Ac Adapter (Main Unit); Change Settings - Oregon Scientific RMR606HGPA User Manual

GETTING STARTED

BATTERIES

Batteries are not supplied with this product. You will need
to purchase 2 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
shows when batteries are low.
UNIT
Main
Remote
RMR606HGPA_R5
LOCATION
Humidity Area when the
INDOOR humidity is
shown.
Humidity Area when the
OUTDOOR humidity is
shown.
7
7

AC ADAPTER (MAIN UNIT)

An AC Adapter is supplied for use with this product. It
must be plugged in for the continuous projection feature
to work. The power jack is located on the back of the
main unit.

CHANGE SETTINGS

1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press UP or DOWN to change settings.
3. Press MODE to confirm.

TABLE STAND

The table stand is located on the back of the product, as
shown below.
9/3/04, 4:16 PM