Set Alarm; Activate Alarm; Snooze Alarm; Temperature And Humidity - Oregon Scientific RMR606HGPA User Manual

SET ALARM

1. Press ((.)).
2. Press and hold ((.)) again for 2 seconds. The Alarm
settings will blink.
3. Select the hour and minute. Press UP or DOWN to
change settings. Press ((.)) to confirm.

ACTIVATE ALARM

((.))
Press to activate or deactivate the Alarm.
in the Clock Area when the Alarm is activated.

SNOOZE ALARM

Press SNOOZE/LIGHT to silence the Alarm for
8 minutes.
If no button is pressed, the Alarm will automatically
silence after 2 minutes. It will then sound again after
8 minutes.

TEMPERATURE AND HUMIDITY

This product can display the following temperature and
humidity information:
• Current, minimum and maximum readings
• Trend line
RMR606HGPA_R5
Data is collected by the remote sensors and displayed
every 40 seconds.

SELECT TEMPERATURE UNIT

Slide the °C / °F switch into the desired location. The
switch is located in the battery compartment. The setting
for the main unit overrides the remote sensor setting.

SELECT SENSOR CHANNEL

shows
Press CHANNEL to switch between sensors 1 - 3.
The icon shows the selected sensor.
Kinetic-
wave
Icon
Display
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEM.
NOTE
temperature data, humidity will not be shown.
11
11
Remote Remote
Indoor
Display Display
Display
Channel 1 Channel 2
If you use a sensor that collects only
9/3/04, 4:16 PM
Remote
Display
Channel 3