Table of Contents
Advertisement
52
EN
Audio Dubbing
Audio cable
Audio component
(CD player etc.)
N O TES:
● When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the Hi-Fi or mixed sound (Hi-Fi + Normal soundtracks),
refer to the "Select The Soundtrack" section (
select the soundtrack you wish to hear.
● Audio dubbing stops automatically when the counter reaches
"0
00
00
", and the VCR enters the Play mode. Check the
H
M
S
counter reading before dubbing.
● Audio dubbing is also possible using the rear AUDIO IN
connectors. When using these connectors, be sure to select
the correct AUX input connector at the Aux Input screen. To
select the correct Aux Input connector, follow steps 4 , 5, 9 –
11 from the "Edit From A Camcorder" section
● Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
● When playing back an audio-dubbed tape, refer to the "Select
The Soundtrack" section (
you wish to hear.
● Picture may be distorted during Audio Dubbing Pause.
● It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
Downloaded from:
https://www.usersmanualguide.com/
q
A. D U B
pg. 27) and
pg. 48.
pg. 27) to select the soundtrack
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack. Use your VCR as the
recorder.
Normal audio track
Video/Hi-Fi audio
track
MAKE CO N N ECTIO N S
Connect an audio component to the AUDIO IN L + R
1
connectors on the VCR's front panel. *When connect-
ing monaural equipment, use only the VCR's AUDIO
IN L connector.
SET IN PUT MO DE
Press N U M BER key "0" on the remote control. "AU"
2
appears in place of a channel number.
● Be sure to select the correct AUX input connector at
the AUX Input Screen. (To select the correct AUX input
connector, follow steps 4 , 5, 9 – 11 from the "Edit From
A Camcorder" section,
LO CATE ST ART PO IN T
Press PLAY to start playback of the tape in your VCR,
3
and press PAU SE when you find the point where you
want to start dubbing.
EN GAGE AUDIO DUBBIN G
Press A. D U B .
4
● Your VCR enters the Audio Dubbing Pause mode.
(REC blinks, PLAY and PAUSE light up on the front
display panel.)
ST ART DUBBIN G
Engage the audio component's Play mode, then press
5
PLAY to start the tape in your VCR. Audio dubbing
begins at this point.
● REC blinks and PLAY is displayed on the front display
panel.
● To stop dubbing temporarily, press
PLAY to resume dubbing.
EN D AUDIO DUBBIN G
Press STO P to stop the tape in your VCR, and engage
6
the audio component's Stop mode.
ED ITIN G (cont.)
Pre-recorded tape
Audio-dubbed tape
pg. 48.)
PAU SE . Press
Advertisement
Table of Contents
