Table of Contents
Advertisement
TRO U BLESH O O TIN G
Before requesting service for a problem, use this chart and see if you can repair the trouble yourself. Small problems are often easily
corrected, and this can save you the trouble of sending your VCR off for repair.
PO W ER
SYM PTOM
1. The power won't come on.
2. The clock works, but the VCR's
power won't come on.
3. The remote control won't function.
TAPE TRAN SPO RT
SYM PTOM
1. The cassette gets stuck partway
during loading, and is ejected.
2. The tape stops during rewind or
fast forward.
PLAYBACK
SYM PTOM
1. The tape is running but the picture
won't appear.
2. Breaks are noticeable in Hi-Fi
soundtrack.
3. The playback picture is blurred or
interrupted, even though TV
broadcasts are clear.
4. The Hi-Fi soundtrack cannot be
heard.
Downloaded from:
https://www.usersmanualguide.com/
POSSIBLE CAUSE
● The power cord is disconnected.
● The TIMER mode is engaged with
Auto Timer set to "OFF" (
● The batteries are discharged.
● The
A/ B CO D E switch is in the
wrong position.
● The
TV/ CABLE/ VCR switch is in the
wrong position.
POSSIBLE CAUSE
● The cassette was inserted incorrectly.
● The Counter Memory indicator
(" M" ) is lit on the front display
panel.
POSSIBLE CAUSE
● If you're using the RF OUT connec-
tion (
pg. 4), the channel selector
on the TV is set incorrectly.
● If you're using the AV connection
(
pg. 4), the TV receiver is set to
the wrong mode.
● Automatic tracking is engaged.
● The video heads may be dirty.
● The AUDIO MONITOR option at
the Audio Select screen was set
incorrectly.
CORRECTIVE ACTION
Connect the power cord.
Press TIM ER to disengage.
pg. 45).
Replace the dead batteries with new ones.
Re-perform the A/B Code setting
(
pg. 56).
Set the switch to the position
corresponding with the unit you want
to operate.
CORRECTIVE ACTION
Make sure the window side is up, the
rear label side is facing you and the
arrow on the front of the cassette is
pointing towards the VCR. Then insert
the cassette
Press C.M EM O RY to disengage the
Counter Memory mode and extin-
guish the indicator (
CORRECTIVE ACTION
Set the channel selector to channel 3
or 4.
Set the TV receiver to its AV mode.
Engage and adjust tracking manually
(
pg. 24).
The heads must be cleaned. Consult
your J VC dealer.
Set AUDIO MONITOR to "HI-FI"
(
pg. 27).
CO N TIN U ED O N N EXT PAGE.
57
EN
pg. 29).
Advertisement
Table of Contents
