Table of Contents
Advertisement
Ca ble Box
Control
Suggested Location
Place the cable box on top of the VCR. Attach the VCR's
Controller to the top of the VCR with the Controller's transmitter
pointed towards the cable box's remote sensor.
Attention:
The Controller can also control a DBS receiver. If both a cable
box and a DBS receiver are used, position the controller so its
signal reaches the remote control sensors of both the cable box
and DBS receiver.
Your VCR
Controller
Your VCR
Downloaded from:
https://www.usersmanualguide.com/
Cable box
Controller
(suggested locations)
Cable box
Transmitter
Connected
Connected to
to VIDEO/
ANTENNA IN
AUDIO IN
CABLE
BOX
This procedure is required if you receive your TV channels
through a cable box (descrambler). The Controller allows the
VCR to automatically switch the cable box channel during
timer-recording. The Controller is effective for recording shows
that have been programmed using G-CODE (
Screen Timer Programming (
Situa te And Connect
Controller
SITUATE CO N TRO LLER
Place the Controller so that the path between its
1
transmitter and the cable box's remote sensor is
unobstructed.
ATT ACH CO N TRO LLER
Fasten securely using the supplied adhesive strips.
2
CO N N ECT CABLE BO X TO
VCR
The connection method depends on the type of cable
3
box you have.
If your cable box has AU D IO and VID EO O U T
connectors . . .
. . . connect them to the AUDIO and VIDEO IN
connectors on your VCR; select the correct external
input mode as described in step 4 , 5 , 9 – 11 on page
50. Set the VCR to channel "AU" to use the cable box.
If your cable box doesn't have AU D IO and VID EO
O U T connectors . . .
. . . connect the antenna output connector on the cable
box to the ANTENNA IN connector on the rear of your
VCR.
Set the VCR tuner to the same channel as the cable box
RF output (see page 14 also).
N O TE:
When connecting your cable box refer to its instruction
manual.
CO N N ECT CO N TRO LLER
TO VCR
Connect to the CABLE BOX connector on your VCR.
4
About Your Cable Box
This VCR has two separate methods to control your Cable Box.
● The VCR's Wireless Remote Control Unit can control your
Cable Box.
This eliminates the need for a separate Cable Box Remote
Control Unit.
● The VCR's Controller can also control your Cable Box.
This allows the VCR to change your Cable Box's channel
number during timer recording.
Each method must be set up separately. To set up the VCR's
Remote Control unit, refer to page 54. To set up the Controller
go to page 14.
13
EN
pg. 40) or On-
pg. 42).
Advertisement
Table of Contents
