Table of Contents
Advertisement
4
EN
Ba sic
Connections
Antenna or Cable
AC Power
Matching Transformer
Cord
(not supplied)
Back of VCR
AC
Outlet
Audio/Video Cable
(supplied)
TV
N O TES:
● The VCR channel is the channel on the TV which will display
the audio and video signals from the VCR. The VCR's CH3-
CH4 switch, on the back of the VCR, sets the VCR channel to
CH3 or CH4.
● The CH3–CH4 switch is preset to the CH3 position.
Set to CH4 if CH3 is used for broadcasting in your area and
set the channel on the TV to correspond to the VCR's CH3–
CH4 switch setting.
● If RF connection to TV is used, when switching from VCR to TV
mode and from TV to VCR it may be necessary to issue a CH UP
and then CH DOWN on TV to obtain a good quality picture.
● Even if you are using AV cables to connect your VCR to your
TV, you must also connect it using the RF cable. This will
ensure that you can record one show while watching another
(
pg. 37).
● For full identification of the VCR's rear panel, refer to the
Index (REAR VIEW
Downloaded from:
https://www.usersmanualguide.com/
ANTENNA IN
(Antenna or Cable input)
Coaxial Cable
Flat Feeder
TV OUT
75 ohm terminal
Back of VCR
CH3
CH4
pg. 63).
IN STALLIN G YO U R N EW VCR
CHECK CO N TEN TS
Make sure the package contains all of the accessories
1
listed in " SPECIFICATIONS" (
SITUATE VCR
Place the VCR on a stable, horizontal surface.
2
CO N N ECT VCR TO TV
The connection method you use depends on the type of
3
TV you have.
RF Connection
● To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV antenna from the TV.
b– Connect the TV antenna cable to the ANTENNA
c– Connect the supplied RF cable between the TV
AV Connection
● To Connect To A TV With AV Input Terminals . . .
a– Connect the antenna, VCR and TV as shown in
b– Connect an Audio/Video Cable between the AUDIO
RF Cable
(supplied)
CO N N ECT VCR TO
PO W ER SO URCE
Connect the power plug to an AC outlet.
4
● The clock and tuner channels will automatically be
set when the antenna is connected and when the AC
is first connected to the VCR (
(If "Auto" or "CH" is displayed on the front display
panel before the VCR is powered on, the clock and
tuner channels are being set automatically. Wait for
the time to be displayed on the front display panel
before powering on the VCR.)
FIN AL PREP ARATIO N FO R
USE
Power on the VCR and select the VCR channel (3 or 4)
5
by setting the switch on the rear of the VCR as shown in
the illustration.
You can now perform simple playback (
simple recording (
pg. 65).
IN jack on the rear of the VCR.
OUT jack on the rear of the VCR and the TV's
antenna terminal. Set TV on CH3 or CH4 corre-
sponding to the CH3 – CH4 switch setting on the back
of the VCR.
the illustration.
OUT and VIDEO OUT jacks on the rear of the VCR
and the AV IN jacks on the TV. Set your TV in video
input mode or A/V input mode. Refer to the TV
Instruction Manual.
pg. 22).
pg. 5).
pg. 21) or
Advertisement
Table of Contents
