Additional Safety Instructions For Sanding; Additional Safety Instructions For Polishing; Additional Safety Instructions For Working With Wire Brushes; Practical Tips - Parkside PWS 125 B2 Translation Of The Original Instructions

GB
Additional safety instructions
for sanding
Special safety instructions for sanding:
• Do not use overly large sand-
paper sheets; follow the
manufacturer's information for
sandpaper sizes. Sandpaper sheets
which extend beyond the sanding plate
can cause injuries and can block, tear
the sandpaper, or cause kickback.
Additional safety instructions
for polishing
Special safety instructions for polishing:
• Let no loose parts of the poli-
shing bonnet, particularly at-
tachment strings. If you shorten
the fastening cords verse defrost
oder. Loose, revolving attachment
strings can capture your fingers or be-
come entangled in the workpiece.
Additional safety instructions
for working with wire brushes
Special safety instructions for working
with wire brushes:
• Be aware that the wire brushes
also lose wire pieces during typi-
cal use. Do not overload the wi-
res by pressing down too hard.
Flying wire pieces can very easily penet-
rate thin clothing and/or your skin.
• If a protective hood is recommen-
ded, do not allow the wire brushes
and the protective hood to touch
each other. The diameter of plate and
cup brushes can enlarge if too much pres-
sure and centrifugal force is exerted.
76

Practical tips

Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cutting disc:
Never use a scrubbing wheel
for cutting !
Only certified, fibre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.

Assembly

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other peo-
ple.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device