enphase Envoy-S Installation And Operation Manual page 27

View Cellular Connection Information
When the IQ Gateway is using the Mobile Connect modem to connect with Enphase Installer App, select >
to view Cellular Configuration information.
View or Change Ethernet Settings
When the IQ Gateway is using Ethernet to connect with Enphase Installer App, select > to view
Ethernet configuration information. From here you can set up for static IP or reset the IP address, if
needed.
WARNING: Do not change the IQ Gateway DHCP setting to use a static IP address
unless you also reserve the same IP address on the broadband router. See the
section on DHCP reservations in the router instructions. Failure to reserve the static
IP address on the router may result in duplicate IP addresses and intermittent
Internet connection problems with the IQ Gateway.
•
To use a static IP address, select Use Static IP and enter information as needed.
•
Select Update. The application asks you to confirm:
This may interrupt communications with the IQ Gateway and require you to reconnect.
•
Select OK to continue, or select Cancel.
27
IQ Gateway Metered Installation and Operation
© 2022 Enphase Energy Inc. 15 Nov, 2022