Redring Selectronic Handbook page 3

To Increase Temperature - Press the warmer button once in the
centre (Confirmed with a single bleep).
The number will change to the new setting.
i.e. Display will change from digit 6 to digit 7.
Wait for a few seconds for the shower to increase the temperature
to the new setting.
Repeat this for your ideal setting waiting each time for the
temperature to be achieved.
To Decrease Temperature - Press the cooler button once in the
centre (Confirmed with a single bleep)
The number will change to the new setting.
i.e. Display will change from digit 6 to digit 5.
Wait for a few seconds for the shower to decrease the temperature
to the new setting.
Repeat this for your ideal setting waiting each time for the
temperature to be achieved.
To Change Flow Rate - Press the flow button once in the centre
(Confirmed with a single bleep)
This reduces the flow without changing the temperature setting.
(Note: As the flow changes, the water temperature may go up and
down slightly).
Press once and the flow will reduce to medium. Press it again and
it will reduce to low.
On switching on the shower, the flow always comes on in the high
flow condition.
Switching Off
When you have finished showering press the Start / Stop button in
the centre. See fig. 1 (Confirmed with 3 short bleeps)
The water will continue to run for a few seconds so that the unit is
cooled down ready for the next time the shower is used.
While this is happening the display will circle round and round (see
fig.5).
The unit will then switch off automatically.
Switch Off Electricity at ceiling / isolating switch.
fig 2.
Press &
wait a few
seconds
fig 3.
Press &
wait a few
seconds
fig 4.
fig 5.
3