Scania L Series Product Information page 94

Recovery and shunting
Unscrew the blanking pieces.
Undo the screws on the rear axle central gear but do not remove them.
Prise off the bearing caps alternately from both sides using two screwdrivers.
IMPORTANT!
If any of the bearing retainers fall off a new universal joint cross with
bearing retainer must be fitted. This is because dirt may have penetrated.
Bearing cap screws
Hold the shaft and remove the screws.
Secure the bearing shells with e.g. adhesive tape.
00:01-08 Issue: 8 en-GB
© Scania CV AB 91 (103)