Detach Propeller Shaft - Scania L Series Product Information

Recovery and shunting

Detach propeller shaft

Propeller shaft, P400-500
Apply the parking brake.
Loosen the bolts in the central gear end yokes but do not take out the bolts.
Prise off the bearing retainers alternately from both sides using two
screwdrivers.
IMPORTANT!
If any of the bearing retainers fall off a new universal joint cross with
bearing retainer must be fitted. This is because dirt may have penetrated.
Hold the shaft and remove the screws.
00:01-08 Issue: 8 en-GB
© Scania CV AB 89 (103)