Scania L Series Product Information page 101

Recovery and shunting
Removing propeller shafts
If the vehicle is recovered with the axles having wheels in contact with the
ground, the propeller shaft should be removed from the driving axle which has
wheels in contact with the ground.
Manual resetting to neutral position when towing
For vehicles fitted with ZF transfer gearboxes.
In the event of problems with the pneumatic system for the transfer gearbox,
or if the vehicle lacks compressed air, you can place it in neutral position for
towing using an adjusting screw on the transfer box.
1. Loosen the lock nut.
2. Screw in the adjusting screw until it stops.
NOTE:
Adjusting screws must be reset by trained mechanics.
For more information about resetting, see 05-00-> GT/GTD 800/801/900/901
-> Repair -> Adjusting high and low gear.
00:01-08 Issue: 8 en-GB
© Scania CV AB 98 (103)