Maintaining Gun - Miller Renegade 180 Owner's Manual

8-7. Maintaining Gun

3
1
2
Tools Needed:
3/8 in
OM-228 042 Page 38
4
3/4 in
(20 mm)
5
.
Complete Parts List available at www. MillerWelds.com
!
Turn off welding power
source/wire feeder.
1 Nozzle
2 Contact Tip
3 Adapter
4 Head Tube
Cut off wire and disconnect gun
from feeder
Remove nozzle contact tip and
adapter from head tube.
5 Liner
Unscrew and remove liner.
Lay gun cable out straight before
installing new liner.
Blow out gun casing.
Reassemble gun in reverse order
from taking it apart. Be sure liner
5
stickout is approximately 3/4 in. (20
mm).
.
Wire size stamped on tip −
check and match wire size.
.
Thread wire according to Sec-
tion 5-13.
Ref. 800 797-D