Ftot Directory; Ftot Mode; Figure 21. Select Ftot Directory - ADTRAN OPTI-6100 User Manual

Hide thumbs Also See for OPTI-6100:

Table of Contents

OPTI-6100 OPTI-APPS User Guide

FTOT Directory

The FTOT Directory is a user-specified directory for storing OPTI-6100 files on the PC, for file

transfer by OPTI-APPS. The default FTOT directory is the OPTI-APPS application folder,

C:\Documents and Settings\[PC username]\OPTI-APPS\.

To configure a different FTOT directory, select File > FTOT Dir. A dialog appears for speci-

fying the new path and directory. (See

When OPTI-APPS connects to an NE, a TL1 session is created for all communications between

the two. FTOT Mode determines if the TL1 session is also shared by FTOT (Shared Session) or

if a second TL1 session is created exclusively for FTOT (Dedicated Session), when FTOT is in use.

NOTE

As a file-transfer protocol, FTOT can require much more bandwidth than

other communications to/from OPTI-APPS. Therefore, FTOT over a

shared session can slow OPTI-APPS performance. A parallel TL1 session

for FTOT leaves other OPTI-APPS functions unaffected, and improves

the efficiency of the FTOT file transfer.

The FTOT-dedicated TL1 session is temporary. It is established when FTOT is used, and is

disconnected once file transfers are completed.

FTOT Mode is only available to GNEs configured for a Connection Type of TCP/IP – Direct.

If configured for TCP/IP – Direct, FTOT Mode defaults to Dedicated Session (but can be

changed to Shared Session).

If Connection Type is TCP/IP – Indirect or Serial Port, FTOT Mode is set to Shared Session,

and cannot be changed.

Figure

21.)

61184568G1-31C

Table of Contents

Opti-apps