Appendix; Q&A On The Use Of The Pfl-E01 - Olympus PFL-E01 Instruction Manual

7. Appendix

Q & A on the use of the PFL-E01
Ｑ１ ： Which electronic flashes can be used with this case?
Ａ１ ： The PFL-E01 case is designed exclusively for the FL-36 Electronic Flash.
Ｑ２ ： What precautions must be taken when loading the electronic flash into the Case?
Ａ２ ： Pay special attention to the following items when loading the flash into the Case.
(1) Check that the remaining capacity of the batteries in the electronic flash is sufficient.
Mount the electronic flash on the hot shoe of the Case correctly and tighten the shoe
lock dial of the electronic flash tightly.
(2) Before sealing the Case, confirm that the O-ring has been installed properly in the Case.
(3) Confirm that the O-ring and the O-ring contact surface are free of dirt, hairs, and other
foreign matter.
(4) Insert the silica gel for defogging. Please use silica gel specified for the Olympus Case.
(5) Confirm that the TTL cable and hot shoe cable are connected properly.
Ｑ３ ： What cautions must be observed when using and storing the Case?
Ａ３ ： Pay special attention to the following items.
(1) When the O-ring contact surface is pressed strongly from the outside of the Case, or
when the Case is twisted, the waterproof function may be impaired and water leakage
may be caused.
(2) When the Case is used, left or stored at the following locations, defective operation or
trouble may be caused. Always avoid such locations.
(a) Places where the Case can reach high temperatures under direct sunlight or in a
car, places with extremely low temperatures, and places with extreme temperature
variations.
En
(b) Places with open fire
(c) Places with volatile substances
(d) Places with vibrations
(3) The following instances could lead to operational problems and/or damage to this case
and the flash inserted in it. Avoid knocks and sudden increase in pressure caused by:
(a) Hitting other objects
(b) Dropping
(c) Placing heavy objects on top of the Case
(4) When the Case is not used for a long time, trouble from formation of mold etc. may be
caused. Before use, confirm the operation of all operation parts and perform the
advance test and the final test.
(5) When not using this case, be sure to take the flash out.
Ｑ４ ： What cautions must be observed when opening and closing the Case?
Ａ４ ： Pay special attention to the following items.
E-23