Olympus PFL-E01 Instruction Manual page 13

Electronic flash waterproof case for the fl-36

Hide thumbs Also See for PFL-E01:

Table of Contents

2)Connecting the hot shoe cable

Connect the hot shoe cable, provided with this case, between the TTL cable connector on

the inner side of the camera case and the hot shoe of the camera. Pay attention to the

following points:

Before inserting the camera into the camera case, loosen and remove the cap on the TTL

cable connector inside the camera case;

Insert the 5-pin connector of the hot shoe cable into the TTL cable connector inside

the camera case;

Turn the lock dial screw on the hot shoe cable's connector all the way clockwise to lock

the connector firmly;

Insert the camera in the camera case;

After inserting the camera, insert the hot shoe unit of the hot shoe cable all the way into the

camera's hot shoe.

The hot show cable can be disconnected by reversing the connection steps. In the final

step, screw the cap back onto the TTL cable connector inside the camera case until it

stops.

CAUTION

： • Pay attention to the position of the 5 pins when connecting the connectors.

• When screwing in the lock dial screw for clamping the hot shoe connector,

• Do not use excessive force when tightening the lock dial screw on the

• When the hot shoe cable is not connected, be sure to put the caps back on

Protective

cap

Lock dial screw

place the Case upside down. Be careful not to drop the Case.

cable's connector.

the TTL cable connectors.

E-11

Table of Contents