2-Port Ds3Ch Tdm Cable Assemblies - Nortel 15000 Hardware Description

2-port DS3Ch TDM cable assemblies

The maximum cable length for DS3Ch lines to customer equipment is 137 m
(450 ft). The distance between the FP and the sparing panel is part of the total
length.
The table
available prefabricated cables. The cable assemblies with standard male BNC
connectors at both ends can be connected to either another FP, the
NTFP99AA sparing panel, the NTHW52 fanout panel, or other compatible
equipment.
Cable assemblies for a DS3Ch TDM FP
PEC
NTFP19AD
NTFP19AE
NTHR69
NTHR70
NTHR71
When a prefabricated interface cable from Nortel Networks is connected
between a DS3 FP and a Nortel Networks termination panel, the connection
is grounded.
You can custom make your own traffic port cables to connect the FP to the
other end connections by using the specifications in the table
parts for a 2-port DS3Ch TDM FP (page
identified in the figure
NTHW91 (page
described in the processor card cabling chapter of NN10600-130 Nortel
Networks Multiservice Switch 15000/20000 Hardware Installation,
Maintenance, and Upgrade.
Cable assembly parts for a 2-port DS3Ch TDM FP
Item
at the FP faceplate, male coax connector
Copyright © 2005, Nortel Networks
- 133 -
Control and function processors
Cable assemblies for a DS3Ch TDM FP (page 133)
Description
male straight BNC to male straight BNC
male straight BNC to male straight BNC
DB9 sparing control port
DB9 sparing control port
DB9 sparing control port
Faceplate of a 2-port DS3Ch TDM FP with PEC
132). Information about assigning port connections is
Nortel Networks Multiservice Switch 15000/20000
Hardware Description
NN10600-120 sPCR6.1S1 Standard
sPCR6.1 February 2005
133). The port connections are
Description
75-ohm straight or right-angle
crimp-on male BNC plug
(connector)
(1 of 2)
Nortel Networks Confidential
lists the
Length
3.0 m (9.8 ft)
15 m (49 ft)
2.5 m (8 ft)
5 m (16 ft)
15 m (49 ft)
Cable assembly