Hisense AKT26UR4RK4 Use And Installation Instructions page 19

·Removing and installing front panel
○ Removal method: Open the front grille. Remove the 4 screws and remove the front panel while pulling
it forward(4 tabs indicated by " ") .
○ Installation method: Secure the front panel with the 4 installation screws(4 tabs) .Return the front grille
to the original position.
3.2 Installation location
·Select the suitable areas to install the unit under approval of the user.
·
The air passage is not blocked.
·
Condensate can drain properly.
·
The wall is strong enough to bear the weight of the indoor unit. If there is a risk that the wall is not strong
enough, reinforce the wall before installing the unit.
·
Sufficient clearance for maintenance and servicing
·Piping between the indoor and outdoor units is within the allowable limits. (refer to the installation of the
outdoor unit )
·
The indoor unit, outdoor unit, power supply wiring and transmission wiring is at least 1 meter away from
televisions and radio, this prevents image inter-ference and noise in electrical appliances. (Noise may be
generated depending on the conditions under which the electric wave is generated, even if a one-meter
allowance is maintained.)
·
If there are 2 units of wireless type, keep them away for more than 6m to avoid malfunction due to cross
communication.
·
When plural indoor units are installed nearby, keep them away for more than 3-4m.
Space for installation and service
Front panel
Front grille
≥50mm
Installation and Maintenance
2 tabs
Remove the front panel
is ensured.
3000~4000mm
Floor
16
2 tabs(1 tab on the left)
≥50mm
Wall