H3C S3100V2 Series Installation, Quick Start page 3

To mount the switch vertically, make sure the network interfaces of the switch face
downwards.采用磁吸垂直安装交换机时，请将交换机网口朝下。
Keep floppy disks and magnetic cards away from
the magnets to avoid erasure of any information.
勿将磁铁与软盘、磁卡等产品接近，否则会引起产
品存储内容被擦除。
Keep computers and monitors that are easily
influenced by magnetic fields away from the
magnets. Otherwise, faults may occur to these
electronic devices.勿将磁铁与计算机、显示器等易
受磁场影响的电子设备接近，否则可能导致电子设
备相关故障。
Connecting the grounding cable 连接保护地线
OT terminal
OT端子
Connect the other end of the grounding
cable to a grounding device另一端连接
接地设备
Connecting the power cable 连接电源线
Before connecting the power cable, connect the grounding cable and make sure that
the s w i t c h is correctly grounded.在连接电源线前，需先连接保护地线，保证交换机
正确接地。
Connect the power cable to the switch first and then to the power supply system to
avoid bodily injury.
连接电源线时，请先完成电源线与交换机侧的连接，再进行电
源线与供电系统的连接，以免造成人身伤害。
Supplied power cable and the installation modes depend on your device model.各型号
标配的电源线及安装方式可能不同，请按照实际情况进行安装。
Connect the AC power cable 连接交流电源线
Without a bail latch无电源线卡钩情况
5
Install permanent
magnets to the four dents
of the switch bottom
在交换机底部的四个圆形印
压区内安装永磁铁
Connect the OT terminal of the
grounding cable to the switch
OT端子与交换机相连
Copyright © 2011, Hangzhou H3C Technologies Co., Ltd.
For more information about the product and installation procedures, log in to www.h3c.com
Copyright © 2011 杭州华三通信技术有限公司 版权所有，保留一切权利。
如需了解产品及安装方面的更多信息，请登录 H3C 网站 www.h3c.com.cn