Siemens SIMATIC NET S7-1200 Operating Instructions Manual page 49

ATEX / IECEx / UKEX / CCC-Ex
Observe the information in the "Use of subassemblies/modules in a Zone 2 Hazardous Area"
document, which you will find here:
• On the documentation DVD supplied with the product, under:
"All documents" >"Use of subassemblies/modules in a Zone 2 Hazardous Area"
• On the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
The conditions must be met for safe usage of the product according to the section Notes on
use in hazardous areas (Page 23).
The product meets the explosion protection requirements outlined below.
Observe installation guidelines
The product meets the requirements if you observe the following during installation and
operation:
• The notes in the section Notes on use in hazardous areas according to ATEX / UKEX /
• The installation instructions in the document /1/ (Page 53)
IECEx
Classification: Ex ec IIC T4 Gc, Certificate no.: IECEx DEK 18.0019X
The product meets the requirements of the standards:
• IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• IEC 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
ATEX
Classification: II 3 G Ex ec IIC T4 Gc, Certificate no.:DEKRA 18ATEX0027 X
The product meets the requirements of the standards:
• EN IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
UKEX
Classification: II 3 G Ex ec IIC T4 Gc, Certificate no.:DEKRA 21UKEX0003 X
The product meets the requirements of the standards:
• EN IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
Importer UK: Siemens plc (see above)
SIMATIC CM 1243-5
Operating Instructions, 01/2023, C79000-G8976-C246-06
WARNING
IECEx / CCC-Ex (Page 23)
Approvals
49