Table of Contents
Advertisement
TrakMax 30L User Manual
Revision 1.0
BAT Indicator
Battery Voltage
Battery Current
4.7.3
Load Interface
The value displayed in this interface is the output voltage and current from the controller to the load; i.e.: the
current being consumed by the load (displayed in Amps).
From the Load Interface, press the ENTER key and hold for 3 seconds to enter setup mode. Once in setup
mode
will blink and "TYPE" will be displayed. Press the UP or DOWN keys to adjust the DC Load to be "ON"
or "OFF". Once correct, press ENTER to save and return to main page.
NOTE: If you do not want to save the setting, press the BACK key to return to main page and original set value.
Load Voltage
Load Current
4.7.4
Battery Capacity Interface
The Battery Capacity Interface displays the battery capacity as set by the user and the temperature at the
Battery Temperature Sensor (BTS) as described in Section 3.8 (displayed in degrees Celsius). The temperature
is used for the temperature compensation of battery charging. The battery capacity can be modified to
accurately depict the end user system.
Default Setting: 200Ah.
To set the Battery Capacity, press the ENTER key and hold for 3 seconds to enter setup mode. Once in setup
mode
will blink. Press the UP or DOWN keys to adjust to the desired value and press ENTER to save and
return to main page. Valid Range: 1 to 999Ah.
NOTE: If you do not want to save the setting, press the BACK key to return to main page and original set value.
Battery Capacity
BTS Temperature
4.7.5
Battery Temperature Compensation Interface
The values displayed in the Battery Temp Compensation interface is the current battery's state of charge and
the current temperature compensation setting as described in Section 3.8.1 (displayed as millivolts per degree
Celsius).
o
Default Setting: 4mV/
o
Note: Set to 0 mV/
C when the Temperature Sensors are not used.
Page 20 of 29
C
windynation
Current Charging Limit
Load Indicator
Load Status
05/06/2015
Advertisement
Table of Contents
