Description Of The Configuration Tool; Closing The Product - Mennekes AMTRON Compact 2.0 11 Operating And Installation Manual

6.5

Description of the configuration tool

The basic settings can be made via DIP switches at
the charging station. The configuration tool is re-
quired for advanced settings.
On initial commissioning, on our website
under "Services" > "Software updates",
check whether there is a newer firmware
version of the product or configuration tool.
Update if necessary.
1 "8.3 Firmware update" [
The following advanced settings can be made:
n Perform firmware update
n Change the default setting (20 A) for the unbal-
anced load limitation (possible values:
10 A ... 30 A)
n Deactivate acoustic feedback
n Deactivate Sleep mode (for reduced standby
consumption of approx. 1 W)
n Activate undervoltage / overvoltage detection
for the connected phases and set the respect-
ive limit values
n Import and export settings
n Change the logic of the downgrade input (de-
fault: downgrade is active when the switching
contact is open)
n Convert the enable input to a pulse signal
In addition, the current operating values are dis-
played and the DIP switch settings are explained in
the configuration tool. Should a fault occur, the con-
figuration tool offers assistance with troubleshoot-
ing (fault message, log file).
To use the configuration tool, the MEN-
NEKES configuration cable is required. You
can find the MENNEKES configuration cable
(order number 18625) on our website under
"Products" > "Accessories". You can also
download the configuration tool and in-
struction manual there.
1 "1.1 Website" [
24]
}
2]
}
The instruction manual for the configuration tool
describes how to install and use the tool.
1 Comply with the configuration tool manual.
6.6

Closing the product

The tasks described in this section may only
be carried out by a qualified electrician.
ATTENTION
Material damage due to crushed components or
cables
Damage and malfunctions can occur due to
crushed components or cables.
u When closing the product ensure that compon-
ents or cables are not crushed.
u Fix components or cables in place if necessary.
Fig. 14: Closing the product
u Fold the top section of the housing upward.
u Screw the top and bottom housing sections to-
gether. Tightening torque: 1.2 Nm.
EN
21